GE AF-600 FP Metasys Operating Instructions Manual page 10

2.1.7 Analog Input Commands (Acknowledged)
DRIVE Re- Subcom-
Command
sponse mand
ACK 1
ACK 1
ACK 1
ACK 1
ACK 1
ACK 1
ACK 1
ACK 1
ACK 2
ACK 2
ACK 2
ACK 2
ACK 2
ACK 2
ACK, no action 7 2
ACK, no action 7 3
ACK, no action 7 7
Table 2.2: No Error code in this table.
Region NPA Object no.
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
- 1 0-23
1 0-23
1 0-23
1 0-23
Attribute
Attribute Message Type
No.
1 Byte Read Analog Input
2 Byte Read Analog Input
3 Float Read Analog Input
8 Float Read Analog Input
9 Float Read Analog Input
10 Float Read Analog Input
11 Float Read Analog Input
12 Float Read Analog Input
1 Byte Write Analog Input
8 Float Write Analog Input
9 Float Write Analog Input
10 Float Write Analog Input
11 Float Write Analog Input
12 Float Write Analog Input
Override Analog in-
- Float
puts
Override Analog Re-
- -
lease
Write Analog Input
- -
Attributes
AF-600 FP Metasys
Comments
Read Object Configuration at-
tribute associated with each
individual point
1)
Read Object Status attribute
associated with each
individual point
2)
Read Analog Input Value at-
tribute associated with each
individual point
Read Low Alarm attribute as-
sociated with each
individual point
Read Low Warning attribute
associated with each
individual point
Read High Warning attribute
associated with each
individual point
Read High Alarm attribute as-
sociated with each
individual point
Read Differential attribute as-
sociated with each
individual point
Write to Object Configuration
attribute associated with each
individual point
Write to Low Alarm Limit attrib-
ute associated with each
individual point
Write to Low Warning Limit at-
tribute associated with each
individual point
Write to High Warning Limitat-
tribute associated with each
individual point
Write to High Alarm Limit at-
tribute associated with each
individual point
Write to Differential attribute
associated with each
individual point
Analog inputs are "outputs"
from the frequency converter
and should not be written over
by the network controller
Analog inputs are "outputs"
from the frequency converter
and should not be written over
by the network controller
Optional command for slave
devices. Only used for N2
commissioning purposes
2
9