Paradyne 9000 Series Installation Instructions Manual page 5

Installing a NAM in a 1-Slot Housing
1. Remove the NAM from its shipping box.
2. Carefully align the NAM connectors with the
integrated I/O card/ backplane (rear panel)
connectors. (See step 3 of Removing a
NAM from a 1-Slot Housing if you need
to open the housing first.)
3. Gently, but firmly press the connectors
together until they are fully seated.
Be careful not to force or bend
any pins.
4. Place the NAM and integrated I/O card/ backplane
into the 1-slot housing's base. Make sure the
backplane rests inside the guides on the
base at the rear of the access unit.
5. Place the cover over the base, aligning the four connecting tabs. Make sure the
backplane rests inside the guides on the cover at the rear of the access unit.
6. Press the cover and base together until all four connecting tabs snap into place.
7. (Re)connect the cables and power cord/transformer.
If this is a new installation, refer to the 9000 Series Access Unit, 1-Slot Integrated
Unit, Installation Instructions (Document Number 9000-A2-GN10).
4
496-15046
496-15047
Guide
496-15048