Test Run - Grizzly G0798 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Model G0798 (Mfd. Since 4/17)
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
4.
Remove switch-disabling key, as shown in
Figure 10.
Figure 10. Removing switch key from paddle
switch.
5. Try to start machine with paddle switch. The
machine should not start.
— If the machine does not start, the switch
disabling feature is working as designed.
— If the machine does start, immediately stop
the machine. The switch-disabling feature
is not working correctly. This safety fea-
ture must work properly before proceeding
with regular operations. Call Tech Support
for help.
-17-