Table of Contents
Advertisement
6.
Install suction panels on rear of downdraft
table so screens face forward (see Figure 6).
Use (16) M5-.8 x 10 flange screws.
Table Plate
Figure 6. Installed suction panels.
7.
Tilt right panel up and attach star knob. Repeat
in similar manner on other side with remain-
ing panel and star knobs (see Figure 6).
8.
Using (4) M6-1 x 15 Phillips head screws,
mount handles on motor access doors, as
shown in Figure 7.
Handle
Figure 7. Star knob and handle installed.
-16-
Suction Panel
Star Knob
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
1.
Turn the machine power switch OFF.
2.
Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Figure 8. Connecting power.
Disconnecting Power
1.
Turn the machine power switch OFF.
2.
Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
Figure 9. Disconnecting power.
Model G0798 (Mfd. Since 4/17)
Advertisement
Table of Contents
