Table of Contents
Advertisement
Replacing Filters
The filters need to be replaced when suction
becomes noticeably reduced. The amount of
use has a direct bearing on how often you must
change the filters.
Wear safety glasses and a NIOSH-approved
respirator rated for the waste metal type
when emptying and cleaning drawers.
Empty only into an approved container, tak-
ing care to minimize amount of dust allowed
to become airborne, and prevent spread
onto hands or clothing. Dispose of waste
properly.
Tools Needed:
A. Phillips Screwdriver #2 ............................... 1
B. Wrench 13mm ............................................ 1
To replace filters:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove table plate and all three support bars
(see Figure 21).
Support Bars
Figure 21. Support bars before removal.
Model G0798 (Mfd. Since 4/17)
Qty
Upper Filter
Lower Filter
3.
Loosen filter knobs counterclockwise to
remove lower filters (see Figure 22).
Figure 22. Lower filters secured by knobs.
4.
Remove both filters and gently knock the dust
off inside a garbage can.
Note: This technique will work two or three
times before filters must be replaced.
5.
Re-install filters. All four filters are identical
in size and can be placed in any designated
spaces.
6.
Re-install filter knobs, support bars, and table
plate.
Never operate machine with damaged or
worn parts. Never operate machine with
filters, guards, or covers removed.
Knobs
-23-
Advertisement
Table of Contents
