Table of Contents
Advertisement
7.
How to use
7-1 Pre-operation check
Check the unit for abnormal condition. Also check that the cables, ducts and tubes are securely
connected.
7-2 Operation
7-2-1 Starting the unit
Turn on the POWER switch on this unit.
The display panel lights up to show the total lamp ON time and operation mode (initial mode is
MANUAL).
LAMP 0000h
MANU 000.0s
Pressing the MODE button enters AUTO mode (The MODE button lights up in AUTO mode).
LAMP 0000h
AUTO 010.0s
7-2-2 MANUAL mode
In MANUAL mode, you can manually turn the lamp on and off without setting the irradiation time.
Press the LAMP ON/OFF button to light up the lamp (the LAMP ON/OFF button also lights up
when the lamp is ON.)
After the lamp lights up, the irradiation time on the display panel starts counting up.
To turn off the lamp, press the LAMP ON/OFF button again. (When the lamp is turned off, the
irradiation time until that point remains displayed and will be automatically reset and start counting
up from 0 when lighting up the lamp again.)
Turn on the POWER switch.
The MODE button lights up in AUTO mode.
The LAMP ON/OFF button lights up
when the lamp is lit.
14
Advertisement
Table of Contents
