Crankcase - Husqvarna 340i Workshop Manual

5.3.2.2 To disassemble and assemble the chain
tensioner
1. Remove the drive sprocket cover. Refer to
the tension of the saw chain on page 14 .
2. Remove the 2 screws and the chain tensioner cover.
3. Remove the chain tensioner (A), shaft (B),
adjustment screw (C), washer (D) and O-ring (E)
from the drive sprocket cover.
B
E
D
A
4. Assemble in the opposite sequence.
1435 - 001 - 11.06.2020
To adjust
C

5.4 Crankcase

5.4.1 To remove and install the front handle
1. Remove the 2 screws (A) on the side of the front
handle.
A
2. Remove the 2 screws (B) at the bottom of the front
handle and remove the front handle.
3. Install in the opposite sequence.
CAUTION: Make sure that the screws are in
the correct positions. If a long screw is
installed at the bottom of the product, the oil
tank can become damaged.
5.4.2 To remove and install the handle insert
1. Remove the screw on the rear handle and carefully
pull out the handle insert.
2. Install in the opposite sequence.
5.4.3 To disassemble and assemble the crankcase
1. Remove the handle insert. Refer to
install the handle insert on page 15 .
2. Move the front handguard rearward to release the
chain brake.
B
To remove and
Repair instructions - 15