Adjusting The Handlebars - Husqvarna 165 R Workshop Manual

Adjusting the handlebars

The left-hand and right-hand halves of the handlebars
can be adjusted to any desired position after slackening
the five screws in the clamp and then the locking screw
underneath. After adjustment, first tighten the five
screws in the clamp and finally the locking screw under-
neath
The purpose of the locking screw underneath is to prov-
ide additional locking of the left-hand half of the handle-
bars and prevent itfrom turning.
We also recommend introducing the locking screw on
earlier cleaning saw models. Dell and tap an M6 hole as
shown in the diagram and fit the locking screw, No. 223
13 64-46 (M6 x 10 mm)
Back off screws A and B. Rotate the handlebar tube
until the throttle control is in the desired position. Tighten
screw A (Fig. 9:2).
Remove the cylinder casing, allowing the throttle lever
to be seen. Turn the throttle control cable by hand until
the throttle lever just touches the choke lever. Note that
the choke control should be in the open position.
Tighten screw B (Fig. 9:2).
Make sure that the two end positions of the throttle
lever, full throttle and idling, can be attained within the
range of movement of the throttle control.
9:1