Settings And Adjustments; Adjusting The Guide Wheels; Adjust The Saw Carriage - Husqvarna WS 440 HF Operator's Manual

Adjusting the guide wheels

In order for the saw to run stably and saw a straight cut, the
four guide wheels must rest against the rail and not have too
much play. When there is too much play between the saw
carriage and rail the guide wheels must be adjusted:
The two marked guide wheels have eccentric axles and by
turning these the carriage is tightened onto the rail.
Start by loosening the marked nuts (1) with the supplied
special tool. Now loosen the two stop screws (2). When these
are loose, adjust the guide wheels (3) against the rail by
turning them towards the rail so the play is taken up. Hold the
guide wheels and screw in the stop screw. Now screw on the
nuts to secure the guide wheels in the new position.
2
3

SETTINGS AND ADJUSTMENTS

1
1
2
3

Adjust the saw carriage

As the saw wears, after a number of hours working, it can be
a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs adjusting:
Loosen the marked (1) socket headed screw (one on each
side of the handle). Now turn the eccentric axles (2) with the
help of the supplied special tool until the axle lies tight against
the saw. Now tighten the socket headed screw.
2
1
English
– 13