Table of Contents
Advertisement
When fitting new spring, check that its engagement point
is opposite a centrifugal weight.
Do not overload the spring on assembly.
Angle gear
Dismantling
Mount the clearing saw in fixture No. 502 5103-01.
Lock the angle gear by inserting a suitable punch (inclu-
ded in the saw toolkit) through the hole in the gear hous-
ing.
Back off the blade nut (left-hand thread) and remove the
support flange, saw blade and driver.
Back off the five blade guard screws and remove the
guard.
Back off the two angle gear clamping screws and the
stop screw (see Fig. 10:9).
Withdraw the angle gear from the drive shaft tube.
Remove the oil filler plug and drain off any remaining oil
in the gear housing.
11:2
Removal of lower bearing housing
and gear shaft
Heat the angle gear with a blowlamp to approx t 30°C.
Clamp the angle gear in a vice with soft Jaws.
Fit puller No 502 50 65-01. Prevent the shad from rotat-
ing by means of an adjustable spanner and tighten the
puller screw hard Withdraw the bearing housing from
the gear housing by means of the puller.
Removal of upper bearing housing
Remove the locking screw.
Flt extractor No 502 50 63-01 and withdraw the bearing
housing from the gear housing.
Hide quick links:
Advertisement
Table of Contents
