Lte Rf Receive Path Test; Table C-3: Test Settings - Receive Path - Sierra Wireless AirPrime MC7710 Product Technical Specification & Customer Design Manuallines

Note: This procedure
describes steps using the
Agilent 8648C signal
generator — the Rohde &
Schwarz SML03 is shown
for reference only.
Rev 6 Mar.13 Proprietary and Confidential - Contents subject to change

LTE RF receive path test

Note: This procedure segment is performed in
page 74.
Table C-3 contains parameters used in the suggested test procedure that follows.
Table C-3: Test settings — Receive path
Mode Test category
a
Frequency
LTE Band
b
Channel
a. All values offset from actual center channel by +2 MHz
b. Channel values shown are at the center of the corresponding bands.
To test the DUT's receive path (or diversity path, while connected to the diversity
antenna):
1. Set up the signal generator:
a. Set the amplitude to -70 dBm
b. Set the frequency for the band being tested. See
values.
2. Set up the DUT:
AT!ENTERCND
a.
AT!DAFTMACT
b.
AT!DASBAND=<band>
c.
· See Table C-3 on page 81
Step 13
B13 B17
(MHz) 753.0 742.0
36 37
23230 23790
(Unlock extended AT command set.)
(Put modem into factory test mode.)
(Set frequency band.)
for <band> values
of the Production test procedure on
Bands
B4
2134.5
42
20175
Table C-3 for frequency
Testing
81