NorthEast Monitoring DR400 Quick Start Manual page 2

DR400 Functions and Modes
FUNCTION DO THIS
When in STANDBY
mode, hold the
TO START
EVENT button
RECORDING
down until green
light goes out
(about 3 seconds)
While recording,
TO RECORD
press EVENT
EVENT
button < 3 secs.
With PCPatch
running, hold
TO VIEW
EVENT button
ECG
until DR400
flashes green
Attach DR400 to
TO STOP
USB cable for at
RECORDING
least 2 minutes
TO SAVE
Attach DR400 to
ECG &
PC where PCPatch
UPDATE
utility is running
SETTINGS
DR400 USB
MODE
CONNECTION
POWER
CHARGING
SOURCE
POWER FULLY
SOURCE CHARGED
INSTALLED
PC
ON PC
COPYING
PC
DATA
ERASING
PC
DATA
NONE RECORDING
NONE STANDBY
DR400 FUNCTIONS:
LIGHT
DR400 will flash
for 60 minutes
DR400 shows
solid orange light.
DR400 does not
respond
DR400 will flash
green slowly for
about 90 seconds
DR400 will flash
green rapidly
when transmitting
Bluetooth data
DR400 connected
to PC
DR400 connected
to PC
DR400 MODES:
LIGHT
Orange –

flashing
Green –

flash every
4 secs.
Green –

solid
Green - fast
DR400 transferring

flashing

Alternating
flashing

Flashes

green to
start and
DR400 storing data
then no

light

No light
and not plugged in
MORE INFORMATION
The DR400 flashes for 30 seconds (v5.04)
or 60 minutes (v5.06) to tell you that

 
Recording did not start as there is either
old data OR no Patient ID on the DR400.

Also, you may see if the recording has
stopped at the end of "Days".
Recording did not start. Most likely, the
DR400 battery is not charged.
Charge using USB power source.

If charged or plugged into USB and no
light is visible, contact Technical Support

An event is being saved.
Takes a few seconds to open window.
The DR400 must be paired with the
NorthEast Bluetooth USB and the PCPatch

 
utility must be running on PC where the
Bluetooth USB is attached.

DR400 will stop recording
Use the PCPatch utility to Preview the file,
Copy the flash.dat file to PC, Erase the file,

update Settings, and pair the DR400 with
Bluetooth USB and/or Gateway(Event)
WHICH MEANS
Once removed from power source,
DR400 charging the DR400 will return to STANDBY
Once removed from power source,
DR400 fully
the DR400 will return to STANDBY
charged
Once removed from PC, the DR400
DR400 visible
will flash quickly for 5 seconds before
to PC
Flash.dat file being copied to Patient
data to PC
Data on DR400 Erasing the DR400 can only be done
being erased
If you are not sure if the DR400 is
recording, press the EVENT button
• If the DR400 flashes green for
about 30 seconds, it is recording
• See FUNCTION-> TO START
RECORDING above for more
DR400 not in use
information about recorder
status
recording has started.
for further assistance.
MORE INFORMATION
mode
mode
returning to STANDBY mode
directory
using the PCPatch utility
down for about 1 second: