Optical (Atm) Line Card Run/Fail Led States - Cisco ASR 5000 Installation Manual

Checking the Card-Level LEDs on the Optical (ATM) Line Card
The location of these LEDs is displayed in the figure below and the various states are described in the following
three tables.
Figure 5: Card-Level Status LEDs for the Optical (ATM) Line Card

Optical (ATM) Line Card Run/Fail LED States

The Run/Fail LED on the ATM line card indicates the overall status of the card. These LEDs are illuminated
steady green for normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 21: Optical (ATM) Line Card Run/Fail LED States
Color
Green
Red
ASR 5000 Installation Guide
24
Description Troubleshooting
Card powered with no None needed.
errors detected
Card powered with Errors were detected during the POSTs. It is likely that the errors
error(s) detected were logged to the system's command line interface during the
boot process.
Refer to the System Administration Guide for troubleshooting
information.
Applying Power and Verifying the Installation