Cisco ASR 5000 Installation Manual page 31

Applying Power and Verifying the Installation
Color
None
Checking the Alarm and Link LEDs on the Channelized Line Card 2
Each CLC2 provides alarm and link LEDs that indicate the status of each port. These LEDs are located at the
bottom of the front panel, as illustrated in the figure below.
Figure 8: Alarm/Link LEDs for the Channelized Line Card
Description Troubleshooting
Card in Ready Mode This is normal prior to configuration. Neither the Active nor
Standby LEDs on the card will be on.
OR
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power OR Card in Active
power and POST test results are positive. If it is off, refer to
Mode
Channelized Line Card Run/Fail LED States, on page 29
troubleshooting information.
Check the state of the Active LED. If it is green, the card is in
standby mode.
Checking the Alarm and Link LEDs on the Channelized Line Card 2
ASR 5000 Installation Guide
for
31