Fcc/Ic Radiation Exposure Statement; Usage Tips - DeLonghi EX 390 Series Instructions For Use Manual

of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and re-
ceiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Approved under the certification provision of FCC Part 15 as a
Class B Digital Device.
Caution: Changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate this
device.
Caution: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device is to comply with
Class B limits. All peripherals must be shielded and grounded.
Operation with non-certified peripherals or non shielded cables
my result in interference to radio or reception.
This Class B digital apparatus complies with Canadian ICES-003.
CAN ICES-3 (B)/NMB-3(B)
WIRELESS TRANSMITTER COMPLIANCE INFORMA-
TION
The term "IC:" before the radio certification number only signi-
fies that Industry Canada technical specifications were met.
This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
This equipment complies with FCC and IC radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm
between the appliance and your body. This transmitter must
not be co-located or operating in conjunction with any other
antenna or transmitter.

FCC/IC RADIATION EXPOSURE STATEMENT

This equipment complies with FCC/IC RSS-102 radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
Host device Labeling
This device includes the following module.
Contains FCC ID: WAP-2011
Host device Labeling
This device includes the following module.
Contains IC: 7922A-2011

USAGE TIPS

• The CST remote control has humidity/temperature sensors
on board. It is suggested not to completely cover it with
hands or clothes; it is as well suggested not to place in ob-
structed air flow zones. In addition to that it is preferable to
keep the device far from direct sunlight exposure or heat
sources in order to avoid miss sensor readings.
• The CST remote control is equipped with touch sensitive
buttons. It is suggested to use it with clean hands and
without dust or liquids/humidity over it.
• The CST Remote control is expected to run for approx. 6
months with the same battery pack. This assumption is
based on the use of 2300 mAh LR6 AA batteries.
11