Vacation And Moving Care - Whirlpool EC510 Use And Care Manual

Vacation and Moving Care
Electrical Shock Hazard
Make sure the ice maker is disconnected
from the main power supply before remov-
ing lower access panel. Failure to do so
could result in electrical shock or personal
iniurv.
To shut down the ice maker:
1. Disconnect electrical power supply to the ice
maker and turn the Cycle Control Knob to
"OFF."
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove two screws from grille area of lower
access panel, then remove the panel.
5. Disconnect the inlet and outlet lines to water
valve. Allow these lines to drain and then
reconnect to the valve.
6. Replace lower access panel and screws.
7. Remove water from drain lines and drain water
pan.
8. Before using again, clean the ice maker and
storage bin.
NOTE: All components of the ice maker are
permanently lubricated at the factory. They should
not require any additional oiling throughout the
normal life of the machine.
13