Cleaning The Ice Maker System - Whirlpool EC510 Use And Care Manual

IY
Thumb screws (long)
Drain
P'KI
Cleaning the ice maker
system -
Personal Injury Hazard
Most ice machine cleaners are citric or
phosphoric acid which can cause irritation
even after dilution. In case of contact with
eyes, flush eyes thoroughly with fresh water
and contact a physician immediately. In
case of contact with skin, rinse well with
water. If swallowed, give large amounts of
water and contact a physician immediately.
Do not induce vomiting. KEEP OUT OF
REACH OF CHILDREN.
1. Turn the Cycle Control Knob to "OFF."
2. Remove the two thumb screws and slide the
ice cutter grid forward, out of the two slots near
the water pan.
3. Unplug the electrical harness.
Any ice on the grid should be melted under
running warm water. Attempting to pick the
ice slab off the grid may stretch and damage
1 arid wires.
4. Remove all ice from the storage bin and the
freezing plate.
.
I
5. Drain the water pan by removing the drain plug
and then replace the plug.
9