Water Filtration System - Kenmore 106.5133 Series Use & Care Manual

WATER FILTRATION SYSTEM

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The filter status light will help you know when to change your
water filter.
Replace the water filter cartridge when the water filter status
■
display changes to turn on.
NOTE: If water flow to your water dispenser or ice maker
decreases noticeably, change the filter sooner. The filter should
be replaced at least every 6 months, depending on your water
quality and usage.
Resetting the Filter Status
After changing the filter, press and hold LIGHT and CRUSHED/
■
CUBED for 3 seconds to reset the filter status light.
The status light will turn off when the system is reset.
Changing the Water Filter
Style 1
A. Water filter cover door.
1. Locate the water filter cover door in the base grille, and pull
open the filter door. The filter will be released and then be
ejected as the door is opened.
2. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the covers
from the O-rings. Be sure the O-rings are still in place after the
covers are removed.
4. With the arrow pointing to the left (toward the filter cover
door's hinge), align the new filter with the filter housing and
slide into place. The filter cover door will automatically begin
to close as the new filter is inserted.
14
A
5. Close the filter cover door completely in order to snap the filter
into place. You may need to press hard.
6. Flush the system. See the "Water and Ice Dispensers" section in
the User Instructions or User Guide.
Style 2
1. Locate the water filter cover door in the base grille, and pull
open the filter door.
A. Water filter cover door.
2. Twist the water filter and turn 90° counterclockwise to unlock.
3. Pull the filter out of the housing.
4. Remove the water filter cap from the water filter.
5. Install the water filter cap onto the new filter. Be sure to align
the arrows so the grooves in filter align with ribs in filter cap.
A