Switch Off Alarm Delay; Resetting An Alarm - Siemens FT2010 Operation Manual

6.2 Switch off alarm delay

6.3 Resetting an alarm

Building Technologies
Fire Safety
An alarm delay in case of alarm is only possible if the fire detection installation is
provided with ↑ 'AVC'. Alarm delay is a countdown until global alarming is initiated.
In case of alarm, the alarm delay can be switched off. Global alarming is triggered
immediately!
Switching off the alarm delay
Press <Alarm delay off>.
κ
 Global alarming is activated immediately.
The alarm message must be acknowledged before 'ALARM' 'Reset'.
In order to 'ALARM'-'Reset', the 'Key switch' must be moved into its horizontal
position.
If the cause of an 'ALARM' is not remedied, a new alarm event will be triggered
after 'ALARM' Reset'.
↑ Person Machine Interface with R button ('Reset')
'ALARM' 'Reset'
1. Turn the 'Key switch' into a horizontal position.
 Operation is released.
2. Acknowledge the alarm message.
3. Press <R>.
 'ALARM' is reset.
 The ↑ floor repeater terminal is in quiescent condition if there are no other
messages.
Operation
Switch off alarm delay
R
21 | 40
009310_l_en_--
2018-08-29
6