Operation; Alarm Procedure - Siemens FT2015 Operation Manual

Operation

4

ALARM Procedure

4 Operation
4.1
Step Action / Condition
1 <Press <Acknowledge> on the Person
Machine Interface
2 Read top line on display
– 'Fire Department requested'
– 'Fire Department in' 'mm:ss'
– 'Call Fire Department !'
When:
Remote transmission switched off

Remote transmission blocked or defective

No remote transmission available

3 Read off fire location in display
4 Go to the fire location
5 Decide: MAJOR INCIDENT or minor incident
Condition
Fire department has been called
'Fire Department in' 'mm:ss'
Count-down runs
'Call Fire Department !'
No automatic transmission to the
fire department
10
Siemens Industry, Inc.
Building Technologies Division
ALARM Procedure
If your fire detection system does not have delayed alarm transmission ('AVC'), the –
'Fire Department in' 'mm:ss' variant doesn't apply to step 2 (see Procedure in the
event of alarm).
Procedure in the event of alarm
MAJOR INCIDENT
Save people
Guide the fire department to the fire
location
Fight the fire
Activate 'Manual pull station'
immediately
Call the fire department on the phone!
To reset, the key switch must be activated.
The room may have to be vented before a reset is possible.
Elements which cannot be reset can be temporarily bypassed on the control panel.
Consequence / Status
'AVC' starts count-down t2 to investigate the
'ALARM' source
'ALARM' is transmitted to the fire department
'ALARM' is transmitted to fire department in 'mm:ss'
Remaining time is shown as Count-down
Fire department must be called by phone!
No automatic transmission to fire department
Minor incident
Try to prevent the fire
department from being deployed
<Press Reset>
<Press Reset>
<Press Reset>
A6V10333444_a_en_US
01/18/2012