RCA 54-45 Manual page 18

6. ( ) Cut both leads on a 150K O , 1/2W, 10 % (brown, green, yellow, silver) RESISTOR, R32, to
-
1/2". CONNECT from TB6-2 (S3} to TB6-3 (S3}.
_1.
( ) Cut both leads on a 330
3/4". CONNECT from TB7-2 (S4} to TB7-4 (S3}.
8. ( ) Cut both leads on a 10KO, 2W, 10 % (brown, black, orange, silver) RESISTOR, R28, to
.,...- 3/4". CONNECT from TB10-1 (S3} to TB10-3 (S2}.
GENERAL: Before going on with the next figure, please review all of the preceding steps pertaining
to Figure 10 for any possible errors.
11. ( ) Mount the (24012} ELECTROLYTIC CAPACITOR, C13, to the REAR CHASSIS, as shown.
(Note the triangle, semi-circle, and square on the bakelite base of the capacitor. Line up these
symbols with the symbols drawn on the figure.) SECURE it by twisting the tabs 1/4 of a turn.
DO
CAUTION:
r-2. ( ) Insert the three SMALL RUBBER GROMMETS, as shown.
,... 3 . ( )
Insert both LARGE RUBBER GROMMETS, as shown.
4. ( )
Snap both No. 6-32 TINNERMAN NUTS into place.
5. ( )
Mount the POT BRACKET, as shown. SECURE it with two No. 6-32 x 5/16 screws, two
,... .. .. . � · No. 6 lockwashers, and two No. 6-32 hex nuts. Under one side place a No. 6 lug, as shown.
?·
( ) Snap the (18017} POTENTIOMETER, R19, to the bracket, as shown. Rotate the POT so
that the lugs are facing the rear chassis.
7. ( ) Mount the REAR CHASSIS, as shown. SECURE it with three No. 6-32 x 5/16 screws, three
- No. 6 lockwashers, and three No. 6-32 hex nuts.
8. ( ) Mount the REAR BRACKET, as shown. SECURE it with two No. 6-32 x 5/16 screws, two
Y-
No. 6 lockwashers, and two No. 6-32 hex nuts.
9. ( ) Mount the RED JACK, J6, to the BOTTOM of the REAR BRACKET, as shown. SECURE by
pressing a retaining ring over the rear of the jack.
10. ( } Mount JACKS J4, J5, and J7 to the REAR BRACKET, as shown. SECURE them by press­
ing a retaining ring over the rear of each jack.
GENERAL: Before going on with the next figure, please review all of the preceding steps pertaining
to Figure 11 for any possible errors.
0, 2W, 10 % (orange, orange, brown, silve1·) RESISTOR, R50, to
FIGURE 1 1
NOT twist the tabs excessively or they may shear off.
17