RCA 54-45 Manual page 17

NOTE: The next step refers to Figure 2.
14. ( ) Mount the TRANSFORMER, Tl, to the chassis and position it so that the RED WIRES face
the REAR APRON as shown in Figure 2. SECURE it with four No. 8-32 x 3/8 screws, four
No. 8 lockwashers and four No. 8-32 hex nuts.
NOTE: The next steps refer to Figure 9.
15. ( ) From Tl twist both BLACK WIRES together. R un them along the chassis, as shown.
CONNECT the SHORT BLACK WIRE to TB8.;; 2 (S2) and the LONG BLACK WIRE
16. ( ) From Tl, connect the SHORT GREEN WIRE to TB8-3 (S5) .
GENERAL: Before going on with the next figure, please review all of the preceding steps pertaining
to Figur.P. 9 for any possible errors.
1. ( ) From TRANSFORMER, Tl, connect the following wires:
L ( ) Connect the RED/YELLOW WIRE to XV3-"GG" (Sl).
a.
Lb.
( ) Connect the BLUE WIRE to XV3-4 (Sl).
t..c .
( ) Connect the WHITE WIRE to :XV3-5 (Sl).
t,t(··/ (
) Route the LONG GREEN WIRE through HOLE "C". It will be connected later.
�e. ( ) Twist both RED WIRES together. Run them along the chassis, as shown. Connect one
lead to :XV6-1 (S2) and the other lead to :XV6-6 (S2).
t,.i..
( ) Twist both YELLOW WIRES together. Connect one lead to XV5-5 (S3) and the other
lead to XV 5-9 (S3).
L.-- g .
( ) Connect the BROWN WIRE to TB5-2 (S3).
2. ( ) Cut both leads on a .1 ufd, 400V, 20 % MYLAR CAPACITOR, C9, to 3/4". CONNECT
. /'
from :XV5-6 (S2) to TB5-3. (S3).
3. ( ) Cut both leads on a 150KI., 1/2W, 10 % (brown, green, yellow, silver) RESISTOR, Rll, to
1/2". CONNECT from TB4-3 (S2) to TB4-2 (C).
_..
4. ( ) Cut both leads on a 47Kil, 1/2W, 10 % (yellow, violet, orange, silver) RESISTOR, R9, to
- 3/4". CONNECT from TB4-1 (S3) to TB4-2 (S4).
5. ( ) Cut both leads on a . 047 ufd, 1600V MYLAR CAPACITOR. C12, to 3 / 4". CONNECT from
--TB6-1 (S3) to TB7-1 (S2). Raise the capacitor off the chassis and away from the transformer.
...
FIGURE 10
16
to
.... .. .
XFl-2 (Sl) .