American Standard SELECTRONIC 606B.111 Installation Instructions Manual page 6

FLUSH OUT SUPPLY LINES; Fig. 6
4
1. Remove STOP VALVE COVER (1) from STOP VALVE (2).
2. Open STOP VALVE (2) with a flat blade screwdriver.
3. Turn on water supply to flush line of any debris or
sediment.
4.
Close STOP VALVE (2) and replace STOP VALVE
COVER (1) .
5
LEFT OR RIGHT HAND
INSTALLATION; Fig. 7
The unit is shipped with the adjustable tailpiece on
the right side. If needed, the orientation can be
modified by following the steps below.
1. Loosen SET SCREW (1) with 2.5mm Hex Wrench (4)
in back of FLUSH VALVE COVER (2).
2. Rotate FLUSH VALVE COVER (2) to the right and lift off.
3. Rotate FLUSH VALVE BODY (3) 180˚
4. Replace COVER (2) and rotate until key engages.
Tighten SET SCREW (1).
INSTALL FLUSH VALVE; Fig. 8, 8a
6
1. Insert ADJUSTABLE TAILPIECE (1) into the STOP
VALVE (2). Lubricate the O-RING (3) with water if
necessary. Lightly tighten COUPLING NUT (4). Fig. 8.
Important: Do not use lubricants (other than water) or
any type of thread sealing paste or tape.
2. Align the FLUSH VALVE BODY (5) directly above the
VACUUM BREAKER TUBE (7) and VACUUM BREAKER
COUPLING NUT (6). Fig. 8a.
Note: There is a +13mm, -6mm (+1/2, -1/4) tolerance for
the 121mm (4-3/4) dimension.
3. Pull the VACUUM BREAKER TUBE (7) up to meet the threaded FLUSH VALVE BODY (5), hand tighten the VACUUM
BREAKER COUPLING NUT (6). Align all components of the flush valve assembly. Fig. 8a.
4. Lightly tighten the COUPLING
NUT (4) connection first,
then the VACUUM BREAKER
COUPLING NUT (6) and
finally the SPUD COUPLING
NUT (8). Once alligned
correctly, use a wrench to
tighten couplings to make
water tight connections.
Fig. 8a.
Fig. 6
Fig. 7
Fig. 8
1
3
4
6
CLOCKWISE CLOSES
STOP VALVE
1
2
4
2
Fig. 8a
2
2
REMOVE COVER
1
2
COUNTER-CLOCKWISE
OPENS STOP VALVE
2
3
180˚
KEY
4
1
121mm,+13mm, -6mm
(4-3/4)(+1/2, -1/4)
4
5
6
7
8
M965644 EN REV. 2.1 (9/18)