COMSPHERE 3000 Series Carrier
.
To install the ferrite choke, refer to Figure 3-38:
Procedure
1. Open the ferrite choke and place it around the ac
power cable as close to the cable connector as
possible.
2. Close the two halves around the cable and snap
the choke shut, pressing down on the plastic latch
to secure it in place.
3. Secure the ferrite choke in place with the cable tie
that is supplied.
3-52
Figure 3-38. Cabling and Ferrite Chokes
Non-Modular Circuit Card Installation
referring to the appropriate Installation and Operation
.
Manual or Applications Guide when necessary:
December 1994
To install each circuit card, proceed as follows,
Procedure
1. Change any default hardware strap settings that
may be required before installing the circuit card
in the carrier.
2. Using a Phillips screwdriver, loosen the screw
holding the circuit pack lock and rotate the lock to
the open position (refer to Figure 3-16). Open the
latch.
3000-A2-GA31-80