Troubleshooting - Beurer BC 16 Instructions For Use Manual

6. Display of the readings saved
The computer automatically saves the blood pressure readings of the last 50 measurements.
When the 50 memory locations are exceeded, the current oldest value is deleted.
You can display the memory as follows:
• Press the "User-Switching key" to select a memory zone, and press the "M" key to switch from memory to
memory with sequence numbers.
• The saved measured values are continuously stored.
• To switch off, press the ON/OFF/START Key again.
• If you forget to switch off the computer, it will switch off automatically after 1 minute.
Press the "User-Switching key" to select a memory zone, then press and hold the "M" key for approximately
5-seconds to clear the data in the pre-designated memory zone. The data in both memory zones – zone 1 and
zone 2 may be erased if any of the batteries is removed.

7. Troubleshooting

Error messages can occur when
• the blood-pressure value is unusually high or low („EE" appears in the display),
• you move or talk during the measurement („EE" appears in the display),
• the cuff tube is not properly inserted („E1" appears in the display),
• inflation takes longer than 20 seconds („E1" appears in the display),
• the inflation pressure is higher than 300 mmHg („E2" appears in the display),
• an error occurs when storing the measured values („E3" appears in the display).
In the about cases, you must repeat the measurement. Make sure that the cuff tube is properly inserted and
that you do not move or talk. Put the batteries back in if necessary, or else replace them.
8. Cleaning/Disposal
• Clean your blood pressure computer carefully only with a slightly moistened cloth.
16