Thermo Scientific Microm HMS 740 Instruction Manual page 40

3-6 STARTING PROTOCOLS
It is possible to start a staining protocol in three
different ways:
1. Via the touch screen in the lower left
corner using
PROTOCOCL". Select a protocol, then
start (Fig. A).
2. Via the quick-start buttons P1 to P5 on
the touch screen (Fig. B).
3. Via the quick-start buttons P1 to P5 on
the touchpad panel at the front of the
instrument (Fig. A).
Caution:
Before starting a protocol, please
always close the hood!
 Open the entry station and remove the cover
from the station. Hook in a basket carrier with a
basket. Close the drawer.
 The "Start" button on the touch screen is now
green.
 In case a protocol is started via a quick-start
button, the protocol is shown on the screen.
Select "OK".
 The selected protocol is now processed.
 A protocol can also be started by pressing the
corresponding quick-start button for two times.
Note:
If the drying stations are used within
the first 5 min., a time delay must be
taken into consideration.
It is not absolutely necessary to start a protocol in
the first step. It can also be started in another one.

Tip onto the button "Start Protocol".

Protocol appears.

Select the desired start step via the arrow
buttons.

The select "OK".

The protocol starts.
40
Thermo Scientific Robot Stainer Microm HMS 740
the button "START
Microm International GmbH
part of Thermo Fisher Scientific
Otto-Hahn-Str. 1A
69190 Walldorf / Germany
387801 - English
Fig. A
Fig. B
Fig. C