Dos About Personal Protective Gear; Dos About Handling Of Hazardous And Toxic Substances; Dos About Handling Emergency Situations; Dos About Waste Oil, Fluid, And Materials - mycom 2016 C Series Instruction Manual

 In the following situations, workers may neglect to perform power source shutoff or
lockout/tagout. Clearly notify the workers of the necessity of lockout/tagout.

It is assumed that workers do not perform lockout/tagout before starting work because it is
troublesome, and only turn "OFF" the main motor and control power.

It is assumed that workers only turn off the main motor and control power and do not
lockout/tagout the main motor and control power, because they judge that there is no
danger.

1.1.1.4 DOs about Personal Protective Gear

 Prepare and use protective gear complying with the safety standards of the regulations.
 Check the function of each protective gear before using.
 Wear designated clothes such as work outfits, with their cuffs tightly closed.

Do not wear any neckties or jewelry as there is a risk of being entangled by a movable part or
rotating part. Put on a helmet as your hair may get entangled.
 Do not have anything in your pocket to prevent objects from falling into the machine.

1.1.1.5 DOs about Handling of Hazardous and Toxic Substances


Obtain the Safety Data Sheet (SDS) from manufacturers of hazardous and toxic substances.
Check the SDS and follow the handling instructions recommended by the manufacturers to
handle and store those substances.

1.1.1.6 DOs about Handling Emergency Situations


Formulate an emergency action plan complying with the regulations, and post it on a safe
place.

1.1.1.7 DOs about Waste Oil, Fluid, and Materials

 Disposing of refrigerant and oil used for this product are subject to a number of regulations for
the environmental protection purposes. Follow the local, state, federal acts and regulations
and your company's rules when disposing of such waste oil, fluid and materials.

1.1.1.8 Other DOs

 Clean the floor around the entire refrigerating/cold storage unit. Provide a safety passage.

Walk only on the areas set up as a work floor. Also, do not leave tools and cleaning solutions
in that area.

If water or oil is spilled on this product or the floor, immediately wipe it off to prevent workers
from slipping and getting injured.
1.1.2

DON'Ts


Do not remove or relocate any safety device, including electrical interfaces.
 Do not disable any safety device by short-circuiting or bypassing without any permission.

Do not leave this product unsafe and unattended, by removing a safety cover or some other
measures.
 Do not touch, clean or lubricate any part of this product which is moving.

Do not touch relays or electric systems such as terminal block with bare hands when turning
on the power.
Compound 2-stage Screw Compressor 2016**C 1.1 Observation/Prevention (DOs and DON'Ts)
1-2
2200LZJE-HO-C6-N_2013.12.
Chapter 1 Safety