Table of Contents
Advertisement
1-5. Installing Optional Board
1-6. Handle
1-7. Installing Battery Adaptor
1-8. Rack Mounting
2. Connect the connector panel to the connector on the
MB-932 board.
3. Secure the connector panel with the two screws
removed in step 1.
B 2.6x4
Connector panel
n
Do not open the slot for an air-cooling effect of this unit.
Attach the blank panel to an empty slot.
1-6. Handle
A handle can be installed on the left side panel of PFV-L02.
The following parts are required.
(They are not supplied accessories.)
. Handle (Part No.: 3-419-372-31) ........................... 1 pc
. Handle tables (Part No.: 2-253-306-31) ................. 2 pcs
. Screws (K 4x14: 7-682-264-04) ............................ 2 pcs
1-7. Installing Battery Adaptor
For the way to install the battery adaptor on this unit, refer
to the supplied Operation Manual.
1-8. Rack Mounting
The PFV-L02 can be mounted on a 19-inch standard rack
for use when two PFV-L02s are joined. Use the specified
rack mounting kit for the rack mounting.
n
For the way to join the PFV-L02s, refer to "1-8-2. Joining
Two PFV-L02s".
1-4 (E)
Specified rack mounting kit: RMM-10
n
PFV-L02 may not be able to be mounted on a 19-inch
standard rack using a rack mounting kit other than the
specified one.
Components of RMM-10
. Rack brackets ......................................................... 2 pcs
. Rack mounting adaptor (right) ............................... 1 pc
[Including two screws (B 4x6: 7-682-560-09)
. Rack mounting adaptor (left) ................................. 1 pc
[Including two screws (B 4x6: 7-682-560-09)
. Rack bracket fixing screws (B 4x6: 7-682-560-09)
........................................................................ 6 pcs
. Adaptor fixing screws (B 4x10: 7-682-560-10)
........................................................................ 6 pcs
*: These four screws (B4x6) are not used.
Required other parts
To mount the unit on the rack, the following parts are
required.
. Screws (RK 5x16: 7-682-378-04) ......................... 4 pcs
. Ornamental washers (2-297-913-01) ..................... 4 pcs
. Supplied accessories of PFV-L02 described in Section 1-
2
1-8-1. Notes on Rack Mounting
w
. Fix the rack on the horizontal and firm floor with bolts to
prevent it from turning over or moving.
If the rack overturn due to the weight of the unit, this
may cause a death or serious injury.
. Use the specified rack mounting kit.
If not, the unit may fall because of insufficient strength.
This causes an injury.
. After rack mounting, be sure to tighten the screws of the
rack angle and fix this unit to the rack.
If not, this unit may slide and fall from the rack. This
causes an injury.
c
Attention when this unit is installed in the rack:
. Be careful not to put your hand or finger in the rack
mounting rail.
. Install in a stable posture.
*
]
*
]
PFV-L02
Advertisement
Table of Contents
