Related Manuals for Sony PFV-D10
Summary of Contents for Sony PFV-D10
- Page 1 DIGITAL INTERFACE UNIT PFV-D10 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher...
- Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
-
Page 3: Table Of Contents
1-3. Power Supply ..................1-1(E) 1-3-1. Power Supply Specifications ..........1-1(E) 1-3-2. Recommended Power Cord ........... 1-1(E) 1-4. Installation Space ................... 1-2(E) 1-5. Installing Optional Board ............... 1-3(E) 1-6. Rack Mounting ..................1-5(E) 1-7. Optional Accessories ................1-6(E) 1(E) PFV-D10... -
Page 5: Manual Structure
Manual Structure Purpose of this manual This manual is the installation manual of Digital Interface Unit PFV-D10. This manual is intended for use by trained system and service engineers, and describes the information for installation of the unit. Contents This manual is organized by following sections. -
Page 6: Related Manuals
PFV-D10. • Maintenance Manual (Available on request) This manual describes the information for periodic maintenance and detailed service. For obtaining the maintenance manual, please contact to your local Sony’s sales representative or service center. 4(E) PFV-D10... -
Page 7: Installation
Installation 1-1. Installation Procedure 1-3. Power Supply 1-3-1. Power Supply Specifications The installation procedure of the PFV-D10 is shown in the following flowchart. Refer to the each item in this manual for details. Power voltage AC 100 V to 240 V... -
Page 8: Installation Space
Do not block the ventilation holes of the unit. Place the unit at least 20 cm away from the walls for ventilation and maintenance. The outer dimensions of the PFV-D10 are as shown in the figure below. 21.5 Unit : mm... -
Page 9: Installing Optional Board
When removing the optional board, turn the board levers in the direction of the arrow 2, then pull out the board 3. Insert the optional board along the board guide rails. toward you. Board guide rail Optional board Component side 1-3(E) PFV-D10... - Page 10 3. Secure the connector panel with the two screws securing the connector cover. Connector panel B 3x6 B 3x6 Attach the connector cover to a dead solt. Opening the slot may cause an electric shock and cannot realize an air- cooled effect of the unit. 1-4(E) PFV-D10...
-
Page 11: Rack Mounting
The following components are required for rack mounting. . Screw (RK 5x16) . Ornamental washer The maximum traveling stroke of the PFV-D10 when mounted on a rack is as follows. Maximum traveling stroke 581 Height to the center of the slide rail... -
Page 12: Optional Accessories
..Optional Board BKPF series (For the details, refer to the supplied operation manual with the PFV-D10.) The optional board BKPF-L series can not install in the PFV-D10..Rack Mount Rail RMM-30 . - Page 13 The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...
- Page 14 Printed in Japan Sony Corporation PFV-D10 (SY) J, E 1998. 12 16 Broadcasting & Professional Systems Company 3-194-471-01 (2) ©1997...