Related Manuals for Sony PFV-L02
Summary of Contents for Sony PFV-L02
- Page 1 INTERFACE UNIT PFV-L02 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher...
- Page 2 4. Prevention against achieving hazardous condition due to uneven mechanical loading When this product is installed in a rack, please make sure that the rack does not achieve hazardous condition due to uneven mechanical loading. PFV-L02...
-
Page 3: Table Of Contents
Handle ....................1-4 (E) 1-7. Installing Battery Adaptor ..............1-4 (E) 1-8. Rack Mounting ..................1-4 (E) 1-8-1. Notes on Rack Mounting ............. 1-4 (E) 1-8-2. Joining Two PFV-L02s ............1-5 (E) 1-8-3. Rack Mounting Procedure ............ 1-5 (E) 1 (E) PFV-L02... -
Page 4: Manual Structure
..Maintenance Manual (Available on request) This manual describes the information for periodic maintenance and detailed service. If this manual is required, please contact your local Sony Sales Office/Service Center..“Semiconductor Pin Assignments” CD-ROM (Available on request) This “Semiconductor Pin Assignments”... -
Page 5: Installation
In the PFV-L02, the following parts used for the mounting contact your local Sony Sales Office/Service Center. on a rack and the joining two PFV-L02 units are provided. . Rack angle (Part No.: 3-203-661-02) ..... 2 pcs . Joint bracket (Part No.: 3-204-705-02) ....1 pc . -
Page 6: Installation Space
Do not block the ventilation holes of the unit. Both of the front and rear sides must be at least 20 cm away from the walls for ventilation and maintenance. The outer dimensions of PFV-L02 are as shown here: 15.3 (During joint of two units) -
Page 7: Installing Optional Board
When removing the main board, open the board lever in the direction indicated by arrow 2 and pull out the board The optional board can be installed in any empty slot of PFV-L02. toward you. Installing Main Board (Front side) 1. -
Page 8: Handle
. Ornamental washers (2-297-913-01) ..... 4 pcs . Supplied accessories of PFV-L02 described in Section 1- 1-6. Handle A handle can be installed on the left side panel of PFV-L02. 1-8-1. Notes on Rack Mounting The following parts are required. -
Page 9: Joining Two Pfv-L02S
For the rack mounting, refer to the Installation Manual of RMM-10. Protectors Be sure to use the screws (B 4x5) supplied with the PFV-L02 when securing the rack brackets. In this case, do Protectors Unit B not use the screws (B 4x6) supplied with RMM-10. If not, Stepped screw this may damage the boards in the unit. - Page 11 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 12 Printed in Japan Sony Corporation PFV-L02 (SY) J, E 2000. 7 22 Communication System Solutions Network Company 3-204-807-01 ©2000...