Table of Contents
Advertisement
2-2-5 Connect chassis ground terminal to earth using # 8 AWG wire.
2-3 Installation:
Where to install.
The power inverter should be installed in a location that meets the following requirements
2-3-1 Dry – Do not allow water to drip or splash on the inverter.
2-3-2 Cool – Ambient air temperature should be between -20℃ and 50℃, the cooler the
better.
See Appendix A for RS232 protocol
•
WARNING!
Any damages caused by using incorrect RS232 cable will be
outside of our warranty scope. If you are not sure which one is
correct RS232 cable, please purchase the correct RS232 cable
from us directly.
WARNING!
Operation of the inverter without a proper ground, connection may
result in an electrical safety hazard.
WARNING!
Shock Hazard. Before proceeding further, carefully check the
inverter is NOT connected to any batteries, and that all wiring is
disconnected from any electrical sources. Do not connect the
output terminals of the inverter to an incoming AC source.
7
Advertisement
Table of Contents
