Safety Precautions - Infineon EVAL-M1-2ED2106S User Manual

EVAL-M1-2ED2106S User Manual
2ED2106S06F drive board for BLDC motor

Safety precautions

1 Safety precautions
Please read carefully the following statements in Table 1 regarding hazards associated with the evaluation
board and the testing system, and the safety precautions listed in the manual.
Table 1 Safety precautions
Caution: The ground potential of the EVAL-M1-2ED2106S board is biased to a negative
DC bus voltage potential. When measuring voltage waveform by oscilloscope, the
ground of the device needs to be isolated. Failure to do so may result in personal injury
or death, and equipment damage.
Caution: Only personnel familiar with the drive and associated machinery should plan
or implement the installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment damage.
Caution: The surfaces of the drive may become hot, which may cause injury.
Caution: The EVAL-M1-2ED2106S board contains parts and assemblies sensitive to
electrostatic discharge (ESD). Electrostatic control precautions are required when
installing, testing, servicing or repairing this assembly. Component damage may result
if ESD control procedures are not followed. If you are not familiar with electrostatic
control procedures, refer to applicable ESD protection handbooks and guidelines.
Caution: An incorrectly applied or installed drive can result in component damage or
reduction in product lifetime. Wiring or application errors such as undersized motor,
incorrect or inadequate DC supply, or excessive ambient temperatures may result in
system malfunction.
Caution: Remove or connect the control board from, or to, the power drive. Wait three
minutes after removing power from the power drive to discharge the bus capacitors. Do
not attempt to service the drive until the bus capacitors have discharged to zero. Failure
to do so may result in personal injury or death.
User Manual 2 of 29 Revision 1.0
2019-09-18