Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-X161 Instruction Manual

GETTING STARTED

1

Cancel the demonstration

When you turn on the power for the first time (or after you reset the unit),
the display shows: "CANCEL DEMO" "PRESS ENTER"
1 Press * ENTER.
[YES] is selected for the initial setup.
Press * ENTER again.
2
"DEMO OFF" appears.
2

Set the clock and date

1
Press and hold .
2 Press VOL +/– to select [CLOCK], then press * ENTER.
To adjust the clock
3 Press VOL +/– to select [CLOCK ADJUST], then press * ENTER.
4 Press VOL +/– to make the settings, then press * ENTER.
Hour Minute
5 Press VOL +/– to select [CLOCK FORMAT], then press * ENTER.
6 Press VOL +/– to select [12H] or [24H], then press * ENTER.
To set the date
Press VOL +/– to select [DATE SET], then press * ENTER.
7
8 Press VOL +/– to make the settings, then press * ENTER.
Day Month Year
9 Press to exit.
4
ENGLISH
To return to the previous setting item, press
3

Set the basic settings

1 Press and hold .
2 Press VOL +/– to select an item (see the following table), then press
* ENTER.
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[SYSTEM]
[KEY BEEP] [ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]* [ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 5)
[SW1 SRC]* [ON]: Enables SW1 in source selection. ; [OFF]: Disables. (Page 5)
[SW2 SRC]* [ON]: Enables SW2 in source selection. ; [OFF]: Disables. (Page 5)
[BUILT-IN AUX]* [ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 7)
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx] [YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
* Not displayed when the corresponding source is selected.
.
.
Default: [XX]