Installation/Connection - JVC KD-X161 Instruction Manual

TROUBLESHOOTING
Symptom
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot
be detected.
• Reattach the device (USB).
"NO DEVICE"
• Sound cannot be heard • Reconnect the Android device.
during playback. • Launch any media player application on the Android
• Sound output only from
the Android device. • Relaunch the current media player application or use
• Restart the Android device.
• If this does not solve the problem, the connected Android
• If USB connection does not work, connect the Android
"NO DEVICE" or "READING" • Reconnect the Android device.
keeps flashing. • If USB connection does not work, connect the Android
Playback is intermittent or
sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
If you still have troubles, reset the unit. (Page 3)
Remedy
this unit and ensure the files are in supported formats.
(Page 13)
Connect a device (USB), and change the source to USB
again.
device and start playback.
another media player application.
device is unable to route the audio signal to unit.
(Page 13)
device through auxiliary input jack.
device through auxiliary input jack.
Turn off the power saving mode on the Android device.

INSTALLATION/CONNECTION

Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come in contact
with metal parts to protect the wires.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of the
speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the speakers.
(Page 11)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on
and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
15
ENGLISH