JVC KD-X161 Instruction Manual page 17

INSTALLATION/CONNECTION
Wiring connection
Signal cord (not supplied)
JVC Amplifier*1
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle factory
wiring harness does not have "12 V ignition
switch" wire.
*2 You can also connect a subwoofer speaker
directly using this lead without an external
subwoofer amplifier. For setting, see
page 11.
Output
terminals
Antenna terminal
Light blue/yellow
Join the same color wires together.
Blue/white: Remote (12 V 350 mA)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left)*2
Green/black*2
IMPORTANT
We recommend installing the unit with a commercially available custom wiring harness specific
for your car and leave this job to professionals for your safety. Consult your car audio dealer.
*1 Firmly connect the ground wire of the amplifier to the car's chassis to avoid damaging the unit.
To the steering wheel remote control adapter
Blue:
To power antenna
Blue/white:
To amplifier
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Brown (not used)
Recommended
connection
17
ENGLISH