Advertisement
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ice SNOWBALL TOSS
Summary of Contents for Ice SNOWBALL TOSS
-
Page 2: Table Of Contents
Table of Contents Safety, Warnings, and Power Requirements Game Controls and Meters Automatic Game Settings Program Options Recommended Bonus Values Error Codes Troubleshooting and Technical Information The Ball gate Assembly Warranty Rev A 11/12/2019... -
Page 3: Safety, Warnings, And Power Requirements
SAFETY AND WARNINGS BEFORE YOU BEGIN WARNING: WHEN INSTALLING THIS GAME, A GROUNDED A.C. RECEPTACLE MUST BE USED. FAIL- URE TO DO SO COULD RESULT IN INJURY TO YOURSELF OR OTHERS. FAILURE TO USE A GROUNDED RECEPTACLE COULD ALSO CAUSE IMPROPER GAME OPERATION, OR DAMAGE TO THE ELECTRONICS. -
Page 4: Game Controls And Meters
Game controls and Meters Located on the center door is the operators control panel. There you can quickly adjust the volume of the game by pressing the “UP” and “DOWN” push buttons. You can view how many coin pulses and tickets has been paid by viewing the meters. To adjust the game’s programming, press the “PROG”... - Page 5 Programming Options for Snowball Option Number Value Option Default Short Description Game Volume Game Volume This option adjusts the general game sounds. Music Volume Music Volume This option adjusts the music in the game and attract mode. Coin 1 Cost of Game How many pulses to start your game.
- Page 6 Score 0 - 40 Tickets for Zone Sets the amount of tickets to win when 0 to 40 points are scored. See Score chart below. Also is used for giving tickets just for playing. Score 50 - 140 Tickets for Zone Sets the amount of tickets to win when 50-90 points are scored.
-
Page 8: Error Codes
Error Codes for Snow Ball - TOP ROW TURNS RED IF ERROR Error 1 Ticket Error DISPLAY SHOWS TIC. Solution: Refill Tickets! See section “When “Tic” appears in the display” Error 2 CF Error ; Compact flash error Solution: Reseat Flash card or replace. Error 3 Ball Gate Closed Error;... -
Page 9: The Ball Gate Assembly
The Ball Gate Assembly: Technical Information Two half-moons attached together and connected to a single motor. The position of the left half-moon is sensed by two reed switches. A small magnet is located under the left moon. When the reed switch is activated, it will be at 0 VDC, the other will be opposite, +5 VDC. - Page 10 Ball-gate sensors Access Remove the two screws that hold the gate cam to the Primary Ball gate assembly. Slide the Primary Ball gate assembly out. Gate Cam Primary Ball Gate Ball-gate sensors Operation There are two magnetic sensors located under the primary ball gate assembly. The primary ball gate assembly has a magnetic attached underneath so that when the assembly rotates it will pass over one of the two sensors.
-
Page 11: Warranty
I.C.E. Inc, at the customer’s expense, within 30 days. After 30 days a 15% re-stocking fee will ap- ply to all returns. ICE distributors are independent, privately owned and operated. In their judgment, they may sell parts and/or accessories other than those manufactured by I.C.E. Inc. We cannot be responsible for the quality, suitability or safety of any non-I.C.E.
Need help?
Do you have a question about the SNOWBALL TOSS and is the answer not in the manual?
Questions and answers