Yamaha TMAX Owner's Manual page 46

Instrument and control functions
In this case, push the select switch to
switch the display in the following or-
der:
F-TRIP Display–1
Display–3 F-TRIP
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
5
(3 mi).
TIP
You cannot enter setting mode (page
5-11) while "F-TRIP" is on.
Estimated traveling range:
The estimated distance that can be
traveled with the remaining fuel under
the current riding conditions is shown.
Ambient temperature:
Display–2
This shows the ambient temperature
from –9 °C to 50 °C in 1 °C increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP
 –9 °C will be displayed even if the
detected temperature is lower.
 50 °C will be displayed even if the
detected temperature is higher.
 The accuracy of the temperature
reading may be affected when rid-
ing under 20 km/h (12 mi/h) or
when stopped at traffic signals
and railroad crossings.
Average fuel consumption:
The average fuel consumption mode
"F.AVE" can be set to "km/L" or
"L/100km". For UK-spec vehicles:
"MPG". (See page 5-14.)
To reset the average fuel consumption,
use the select switch to select the in-
formation display page that contains
the average fuel consumption display.
Push the "
so that the average fuel consumption
display
the "
for 1 second while the display is flash-
ing.
TIP
After resetting the average fuel con-
sumption display, "– –.–" will be shown
until the vehicle has traveled 1 km (0.6
mi).
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
5-10
" side of the select switch
flashes, and then
" side of the select switch again
ECA15474
push