Reference Information
Step 13
Step 14
Step 15
Step 16
Using Flash Memory Cards
The Flash memory (PCMCIA) card slots on the front panel of the RSP1 are for additional
PCMCIA-based Flash memory for your system. You can use this Flash memory to store and run
Cisco IOS images, or as a file server for other routers to access as clients. Occasionally, it might be
necessary to remove and replace Flash memory cards; however, removing Flash memory cards is not
required and is not recommended after the cards are installed in the slots.
36 Route Switch Processor (RSP1) Installation and Configuration
Using the config-register 0x<value> command, change the configuration register value
back to its original value (noted from Step 3) or change it to a value of 0x0101 (factory
default).
Exit the configuration mode by entering Ctrl-Z.
Reboot the router and enable it using the recovered password.
This completes the procedure for recovering from a lost password.