Cisco RSP1 Installation And Configuration Manual page 41

Route switch processor

Table of Contents

To enable the router, copy the image new.image to the Flash memory card, make this image

Step 3

in the Flash memory card (in slot 0) the default boot image, and reboot the router, use the

following series of commands:

Router> en

Password:

Router# copy tftp:new.image slot0:new.image

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

In the preceding example, the exclamation points (!!!) appear as the ﬁle is downloaded and

Note

the "C" characters signify calculation of the checksum, which is a veriﬁcation that the ﬁle has been

correctly downloaded to the Flash memory card.

Router# config terminal

Router(config)# no boot system

Router(config)# boot system flash slot0:new.image

Crtl-z

Router# copy running-config startup-config

Router# reload

When the system reloads, it will boot the image new.image from the Flash memory card in slot 0.

Route Switch Processor (RSP1) Installation and Configuration

Reference Information

Table of Contents

Mem-rsp-8m Mem-rsp-16m Mem-rsp-24m Mem-rsp-32m Mem-rsp-64m Mem-rsp-128m