Cisco RSP1 Installation And Configuration Manual page 26

Reference Information
Step 4
Figure 6
Step 5
Step 6
Step 7
This completes the SIMM removal procedure. Proceed to the next section to install the new SIMMs.
26 Route Switch Processor (RSP1) Installation and Configuration
Release the spring clips from the SIMM that you want to remove and release the SIMM
from the socket. (See Figure 6.)
Releasing the SIMM Spring Clips
Faceplate edge of
the system card
When both ends of the SIMM are released from the socket, grasp the ends of the SIMM
with your thumb and forefinger and pull the SIMM completely out of the socket. Handle
the edges of the SIMM only; avoid touching the memory module or pins, and the metal
traces, or fingers, along the socket edge.
Place the SIMM in an antistatic bag to protect it from ESD damage.
Repeat Steps 4 through 6 for the remaining SIMMs, as required for your upgrade.
Pull the tabs away with
your thumbs, bracing your
forefingers against the
posts. Raise the SIMM
to a vertical position.
Polarization notch
DRAM SIMM card