Cisco RSP1 Installation And Configuration Manual page 37

Replacing a Flash Memory Card
It might become necessary for you to replace or install a Flash memory card in your RSP1. The RSP1
has two PCMCIA slots: slot 0 (bottom) and slot 1 (top). (See Figure 9.) The following procedure is
generic and can be used for a Flash memory card in either slot position.
Note
Before you install a card, verify that the Flash memory card is set with write protection off. The write
protect switch is located on the front edge of the card when oriented with the printing right side up
and the edge connector end away from you. (See Figure 8.)
Figure 8
Flash card
write protection
Following is the procedure for installing and removing a Flash memory card:
Step 1
Step 2
Step 3
Step 4
The Flash memory card can be inserted and removed with the power on.
Locating the Flash Memory Card Write Protection Switch
Flash card
Face the front panel of the RSP1 (as shown in Figure 9a), and hold the Flash memory card
with the connector end of the card toward the slot. The connector end of the card is the end
opposite the end with the write protection switch, which is shown in Figure 8.
Insert the card into the appropriate slot until the card completely seats in the connector at
the back of the slot and the eject button pops out toward you (See Figure 9b.) Note that the
card does not insert all the way inside the RSP1; a portion of the card will remain outside
the slot. Do not attempt to force the card past this point.
To eject a card, press the appropriate ejector button until the card is free of the connector at
the back of the slot. (See Figure 9c.)
Remove the card from the slot and place it in an antistatic bag to protect it.
Flash card
shown with write
protection off
Route Switch Processor (RSP1) Installation and Configuration
Reference Information
37