Installation - ELPRO TZM1612 Manual

TZM1612
3.0 SETTINGS
The unit does not have user presets.
Certain presets for functioning of the unit can be made directly from the keypad (See par. 5.2)

4.0 INSTALLATION

a) Make sure that all the units to be installed are off.
b) Connect the sources and the destinations according to the screen-printed instructions on
the rear panel.
Looping of the units is not possible. If necessary, duplicate
the incoming signal with an Elpro WS300/2 type unit.
Some monitors or video-projectors fitted with the HDD15p.f.
c) Connect the audio sources and the destinations according to the screen-printed
instructions on the rear panel.
Remember that the inputs and the outputs audio are balanced. If the source to be connected
to the input has an unbalanced output, put the hot signal on input a of the TZM1612, connect
the ground of the signal and input b to GND.
ELPRO Video Labs s.r.l.
5
Via della Praia 4/a FERRIERA di BUTTIGLIERA ALTA (TO) – ITALY
Tel.+39 0119348778 - FAX +39 0119348779
WARNING
The RGB inputs are terminated at 75
WARNING
connector require setting of pin # 5 to GND
16x12 RGBHV & AUDIO MATRIX
Ω
.