ELPRO TZM1612 Manual page 10

TZM1612
6.0 FUNCTIONS WITH IR REMOTE CONTROL
The unit is equipped with a receiver for an infra-red remote control that must be ordered
separately (code IRTZM1612)
The remote control is of the self-learning type. After inserting the batteries and each
time these are changed, press the "Set" key for a few seconds
IR remote control reception is enabled and disabled
The unit is shipped with reception from IR remote control enabled.
The following functions are performed with the IR remote control:
1) Setting of switching operating mode:
V, A, A+V, LOOK
2) Switching:
IN followed by Key 1÷16
OUT followed by Key 1÷12
3) Save the preset (machine states):
SAVE followed by Key 1÷8
4) Recall (machine states):
RECALL followed by Key 1÷8
RECALL command are not performed "through blank"
holding down the MODE button at power-on
(Same as for built-in keypad)
Selection of an input
Selection of an output
Remember that switching operations invoked by a
Via della Praia 4/a FERRIERA di BUTTIGLIERA ALTA (TO) – ITALY
16x12 RGBHV & AUDIO MATRIX
WARNING
WARNING
Preset command
Recall of preset
WARNING
Tel.+39 0119348778 - FAX +39 0119348779
ELPRO Video Labs s.r.l.
10