Advertisement
CHAPTER 13 S1C88 FAMILY DEBUGGER
ICE hardware error messages
Error message
Error : Cannot be run in Free-Run mode
Error : Cannot fine specified data
Error : ICE88UR is still keep a conservative mode The ICE is operating in maintenance mode.
Error : ICE88UR power off execution abort
Error : Insufficient memory for loading program
Error : Vdd down or no clock
Error : Verify error
ICE88UR system error : ?? illegal packet
ICE88UR system error : Command timeout
ICE88UR system error : Firmware packet error
ICE88UR system error : Master reset
ICE88UR system error : Not connected
ICE88UR system error : Not ready
Internal error : ICE88UR does not support this
command version
Internal error : Illegal error code fetched.
System crash possible
Processing terminated by hitting ESC-key
202
The ICE is operating in free-run mode.
The specified data could not be found.
(The search failed to find matching data.)
Power to the ICE main unit is off. Execution was aborted.
(Power to the main unit has been shut off while running the program.)
Failed to allocate memory for the program.
(Windows system resources may be insufficient.
Check available resources and quit unnecessary applications.)
The power supply voltage for the target system is low, the target system
is not powered on, or no clocks are supplied to the target system.
(Effective only when Vdddown is set to 1 in the parameter file.)
A verify error occurred.
Detected an illegal packet.
Detected a command time-out.
Detected an error in EB: Firmware packet.
Detected MR: master reset.
The ICE is not connected or powered on.
The ICE is not ready.
The current version of the ICE does not support this command.
(Please shut down the DB88 debugger immediately.)
Nonexistent error code has been encountered.
(Please shut down the ICE88UR debugger immediately.)
Processing terminated because the ESC key was pressed.
EPSON
Description
S5U1C88000C MANUAL II
WORKBENCH/DEV TOOLS/OLD ASSEMBLER
Advertisement
