Setup With Motor Nearby; Required Components; Table 2-5: Components Required For Setting Up With The Motor Nearby - Siemens ECOFAST Manual

2.3

Setup with motor nearby

2.3.1

Required components

The table below shows which components are required:
Item Order data
1 Motor starter
2 4 fixing screws, 5 mm dia., if necessary nuts,
spring washers, plain washers
3 Power cable for motor starter - motor connection
Han 10E
prefabricated
or prepared by customer
4 Power cable for looping through power
Han Q8 pin / power tee connector
prefabricated
or prepared by customer
Power cable, no looping through of power
Han Q8 at both ends
prefabricated
or prepared by customer
5 AS-i cable, trapezoidal-section yellow,
rubber 2 x 1.5 mm
6 AS-i cable, trapezoidal-section black,
rubber 2 x 1.5 mm
AUX PWR
7 Cable end covers for sealing open
cable ends (1 set = 10 covers)

Table 2-5: Components required for setting up with the motor nearby

ECOFAST Motor Starters
GWA 4NEB 950 0562-12
2
for fieldbus
2
for ext. 24 V auxiliary voltage
Installation of Motor Starters
Order number
3RK1 3..
depending on version
3RK1 911-0.. depending
on length, cross section,
Han 10E one end/
both ends
3RK1 911-0.. depending
on length and cross
section
3RK1 911-0.. depending
on length and cross
section
3RX9 01.-0AA00
depending on length
3RX9 02.-0AA00
depending on length
3RK1 901-1MN00
2-5