DURKOPP ADLER D867 Additional Instructions page 11

Ssd with rfw

Hide thumbs Also See for D867:

Table of Contents

Assembly

Fig. 6: Assembling the SSD (2)

(1) - Blow tube

4. Halve the hose A (2.2 m).

5. Fit the hoses onto the blow tube (1) and the sensor block (2).

6. Tighten the sensor block (2) on the hook support.

7. Tighten the blow tube (1) on the hook support.

8. Tilt the machine head.

9. Pull the cables and hoses through the base plate and to the underside

Additional Instructions D867 - 00.0 - 04/2020

①

While doing so, press the sensor block (2) against the casting and slide

it to the right in the screw hole to position it correctly.

While doing so, align the blow tube (1) such that the flow of air hits

the polished surface of the bobbin case.

of the machine.

②

(2) - Sensor block

Table of Contents