IBM 5280 User's Setup Procedures page 50

44
16. Label the IBM binder(s) that came with your device (if they
have not been labeled) by doing the following:
a. Open an IBM binder and cut out the identification tab printed on
the back cover of each manual.
b. Fold the identification tabs (except for the first tab) in the
following manner:
Note: Depending on the binder, you may only have two tabs to insert.
MANUAL NAME
MANUAL NAME
First Tab
..
' - - - - - - - - . -
MANUAL NAME
c. Insert the tabs into the plastic cover found on the binder, as
shown below:
MANUAL NAME
MANUAL NAME
MANUAL NAME
Plastic Covs'r
You have completed the setup procedure for the 5286. Go to Section 7,
Labeling Your System. After you have completed the labeling procedures, you
will be sent to Section 8, Verification Procedure.