IBM 5280 User's Setup Procedures page 130

124
68. Observe this display.
This display will appear for approximately 10 seconds.
COtllfilU11ICdt iOllS
tf.~st
In pl-nceS5.
l
57-02
J
~--------"
J 1. If the top line of the display starts blinking, press the
Reset or Error Reset key. The following display will
appear:
Test Ter"ill i nated.
:1. F<ESH,RT
2. EXIT
SeL[ict option:
'") Pr"ess EN1EF(
l~
_ _ _
J2. Press the number 1, then press the Enter key.
Repeat step 59 through 68. If the top line of the display
starts blinking again, record the four-digit error code
number for reference and call your service
representative.