Section 10. Disconnecting And Relocating Your System - IBM 5280 User's Setup Procedures

Section 10. Disconnecting and Relocating Your System
As your installation grows, it may become necessary to disconnect and relocate
your system. Many of the planning and site preparation activities planned for
the setup of your system should be reviewed in the IBM Planning and Site
Preparation Guide, GA21-9351. If relocating your system requires packing
materials, contact your marketing representative.
Use the following procedure for each device:
1. Set the Power switch to the Off (0) position.
2. Unplug the power cord plug.
3. Remove all diskettes and leave the diskette locking lever
open.
4. If you have the Keylock feature, position the key to the locke d
position and remove the keys.
5. On the 5282 and the 5286, remove the mirrors from each side
of the data station and carefully wrap each one; then tape
the mirrors to the top of the data station.
6. If you have magnetic stripe readers, wrap and tape them to
the data station.
7. Identify each cable:
a. Look at the cable to be sure that the label is still attached to it.
If not, make a label and include the following information for
each cable:
Aux Data Station _ _ _ _ _ _ _ _
Location _ _ _ _ _ _ _ _ _ _ _
Socket or Prog Unit _ _ _ _ _ _ _
Device Address _ _ _ _ _ _ _ _ _
b. Coil each cable and wrap with tape.
Caution: The cables and cable connectors are durable, but can be
damaged if stepped on or thrown.
User's Setup Procedures 145