Electrical Connection - U.s.a. Only - Whirlpool Cabrio W10164159B Use & Care Manual

Power Supply Cord
WARNING
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
A B
A. Terminal block cover
B. Hold-down screw
C. External ground conductor screw
D. Center, silver-colored terminal block screw
E. Neutral ground wire
F. Hole below terminal block opening
3. Install strain relief.
Style 1: Power supply cord strain relief
■ Remove the screws from a
marking on strain relief). Put the tabs of the two clamp sections
into the hole below the terminal block opening so that one tab is
pointing up and the other is pointing down, and hold in place.
8

Electrical Connection - U.S.A. Only

D
C
3 / " (19 mm) UL listed strain relief (UL
4
Direct Wire
Use 10 gauge solid copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Tighten strain relief screws just enough to hold the two clamp
sections together.
E
F
■ Put power supply cord through the strain relief. Be sure that the
wire insulation on the power supply cord is inside the strain
relief. The strain relief should have a tight fit with the dryer
cabinet and be in a horizontal position. Do not further tighten
strain relief screws at this point.
WARNING
Fire Hazard
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
A
B
C
D